- Questions
- Engine
Votes
Answers
Views
Question
1
vote
2
answers
31
views
1
Category:
Engine
I have a stock bottom end 350. Originally a vortec 880 block. Fairly low mileage deal with cross hatching still in the cylinder walls. Bores measure out and should be fine with a ball hone. Low buck type of a deal reusing the stock crank, rods and pi...
2
votes
1
answer
18
views
1
Category:
Engine
I have a Chevy small-block that has been sitting for almost 20 years. Any tips before I try to start it up?
3
votes
3
answers
33
views
2
Category:
Engine
I've recently developed this tap on my 383 and have adjusted the valves 4 times. It sounds like a valve tap but I think it's something else. Can you tell what it is?
4
votes
1
answer
14
views
1
Category:
Engine
My 1956 Chevy Belair 235 6 cylinder has a power loss and backfire with sharp acceleration. Slow acceleration when parked motor responds well. This also results in very poor drivability until vehicle is up to speed. Compression is 100 across the board...
0
votes
1
answer
15
views
1
Category:
Engine
I am trying to remove my intake and exhaust manifolds to replace the original gaskets. Surprisingly, a daily dose of penetrating oil made extremely easy work of all bolts for both manifolds. Except there always has to be ONE right! The problem is tha...
0
votes
0
answers
33
views
0
*
Category:
Engine
My Camaro started having trouble starting, is running rough and is misfiring. I've changed all the filters and still cannot identify the issue. Any ideas?
5
votes
2
answers
73
views
1
Category:
Engine
Has anyone seen this with an AWD 4 Rotor shooting flames after high RPM? See attached video from my DYNO testing. Thanks for any help!
